Table des matières

Installing and configuring the IP Label web plugin

Installation

To install the IP-Label Web Plugin on your Galaxy and Infinity, simply type the following command lines:

none
apt update
apt install esia-webp-iplabel

The Web Plugin is now installed and you can connect to your Esia interface.

Adding the node

Go to administration and click on add node.

Enter the name, node group, etc. and, most importantly, specify the “IP Label” node type. Then click on add.

Now enter your server's connection details.

Click on “Save”, if all goes well the following message will appear.

Your node is now added to Esia.

Supervision of a robot

Go to the node's “control” page after a few minutes (7-8 minutes) the “Last synchronisation” service will change from grey to green and the following page will be available.

To add supervision of a Robot, you can click on the “Robots” tab and select the one you want. To finish, click on add.

Supervising a scenario

Go to the node's “control” page and click on the “scenarios” tab. Then select the one or ones you want. To finish, click on add at the bottom of the page.